NanoMoldCoatingtm is a self applied(in house), non-migrating hard coating (not an aerosol spray), which facilitates part release for up to 500,000 cycles per coating, and it&＃39;s only 100 nanometers thick. It reduces cycle times, increases production, and minimizes downtime.Nano Mold Coating Benefits:Increased Productivity (Decreased downtime due to removing stuck parts, and restarting) Easily applied in house (approximately 10-15 minutes) You don&＃39;t have to send tools out for coating and repairs. Facilitate release for up to 500,000 shots per coating Eliminate part rejects due to streaking and dragging upon mold fill Minimize or eliminate ejector pin push marks Maintains dimensional integrity of molds (coating is hardened and is only 100 nanometers thick. It is immeasurable) Eliminate the need for aerosol release agents (major cost savings) Reduction in molding pressures (due to lowered coefficient of friction) Does not migrate to parts (so contamination on parts and painting of parts is not an issue) Acts as a rust and corrosion inhibitor Non-toxic Can be applied to all mold material